Connecting The Cables To The Controller Pca - HP 6000 SERIES Hardware Installation Manual

Hardware Installation Manual HP Series 6000
Connecting the Cables to the Controller PCA
Note
Do not alter any jumpers on the option pins that have been
installed and preset by the factory.
1. Connect the appropriate address cable to the SCSI address cable on the drive
(see Figure 5-5). The address cables in the mass storage system are numbered
according to slot number.
2. Connect the internal SCSI cable to the controller PCA (see Figure 5-5).
3. Connect the control cable to the controller PCA.
4. Connect the data cable to the controller PCA.
5. Connect one of the split ends of the dual dc power cable to the controller
PCA.
6. Connect the long end (14-pin connector) of the dc power cable to any of the
unused dc power connectors on the power supply (see Figure 1-7).
5·8 Rewritable Optical Disk Drive Installation