HP 6000 SERIES Hardware Installation Manual page 45

HP Series 6000 Hardware Installation Manual
Options/Address Jumpers
The options/address jumpers on the drive (see Figure 3-2) enable you to select
options and set a unique SCSI address for your 3.5-inch hard disk drive. The
address is set with the rear panel SCSI address switches (refer to Figure 1-2 and
Table 1-1).
Caution
,
The options jumpers
must
be left in the factory-set positions.
These settings are shown in Figure 3-2. Make sure the address
switch on the mass storage system rear panel is set to a unique
SCSI address relative to the other devices on the SCSI bus. The
mass storage system will not function properly if two devices
have the same SCSI address.
3.S·inch Hard Disk Drive Installation 3·3