HP Series 6000
Hardware Installation Manual
Connecting the Power Cord
The various power cords available are shown in the Disk Product Specifications
and Site Environmental Requirements Handbook, part number 5955-3456. Each
mass storage system is shipped with an appropriate power cord.
Warning
Note
• The ac branch service must be properly current-protected
by either a fuse or a circuit breaker.
• Use only a UL/CSA approved power cord, SVT type, rated
for suitable voltage and current. These power cords have
two conductors plus a ground. Failure to use the proper
power cord could result in a shock or fire hazard.
• Do not open the power supply. The power supply contains
no customer-serviceable parts.
Your mass storage system has an automatic ranging power
supply. This means that a voltage selector switch and external
fuse are unnecessary. Automatic ranging power supplies have
internal fuses that only fail if the power supply malfunctions.
To attach the power cord:
1. Set the
[LiNE-)
switch to the 0 (out) position.
2. Connect the female end of the power cord to the -AC LINE connector at the
rear of the mass storage system.
Mass Storage System
1·5