Status Indicators; Introduction; Set The Ip Network Address - Allen-Bradley 2100-ENET Quick Start Manual

4 Quick Start Guide for Configuring an E3 Plus EtherNet/IP Adapter

Status Indicators

The adapter uses four status indicators to report its operating status.
Status Indicators
Status Indicators
Item Name Color
1 PORT Green
2 MOD
3 NET A Green
4 NET B

Introduction

The E3 Plus EtherNet/IP Adapter module is a linking device that lets users connect an E3 or E3
Plus Solid State Overload, 825-P Motor Protection System, or IntelliVAC+ module directly to
an EtherNet/IP network. This document explains the basic steps needed to configure the E3
Plus EtherNet/IP Adapter module.

Set the IP Network Address

The E3 Plus EtherNet/IP Adapter module ships with Bootstrap Protocol (BOOTP) enabled.
You can set the network Internet Protocol (IP) address by using the BOOTP/DHCP Server
that is provided with RSLinx Classic software. This utility recognized BOOTP-enabled devices
and provides an interface to configure a static IP address for each device.
To assign network parameters via the BOOTP/DHCP utility, perform this procedure.
1. Start the BOOTP/DHCP software.
Rockwell Automation Publication 2100-IN090A-EN-P - February 2012
State Description
Flashing Normal Operation. The adapter is establishing an I/O connection to the E3 Plus
overload relay. It will turn steady green or red.
Steady Normal Operation. The adapter is properly connected and communicating with
the E3Plus overload relay.
Flashing Normal Operation. The adapter is operating but is not transferring I/O data to a
controller.
Steady Normal Operation. The adapter is operating and transferring I/O data to a
controller.