E L A N H O M E S Y S T E M S
Video Termination Switch
When the video signal coming into a VIA! Touch Panel is to be looped back
out of the panel to another VIA! or TV, the Video Termination Switch must be
moved from the factory default 75 Ohm TERM position to the OPEN posi-
tion as shown in Figure 3.8.
Note: The illustration shows a VIA!40-EM. The Video Termination
Switch is identical in all respects on the VIA!7.0-EM and
VIA!10.0-EM.
Video In/Loop Out Configuration
Often, VIA! Touch Panels will be installed in conjunction with other VIA!
Touch Panels and/or televisions located in the same area. There are two sce-
narios that can be utilized:
• Each VIA! and/or TV displays the same video.
A single video feed is routed through the VIA! to additional
VIA!s or TV(s).
• Each VIA! and/or TV displays video independently.
Independent video feeds are routed to each VIA! and/or TV.
© ELAN Home Systems 2007 • All rights reserved.
75Ohm TERM
(Factory
Default Position)
Figure 3.8: Video Termination Switch
VIA!4.0-EM/VIA!7.0-EM/VIA!10.0-EM
OPEN Position
Page 21