Purpose of this Manual This manual provides step-by-step installation instructions and connection examples, along with basic user information for installation and ongoing use of the TS7. This manual is written for the installer of this equipment. Organization The following information is contained in this manual.
ELAN System Controllers and multiple sub-systems. The TS7 features a 7” Active Matrix LCD with 800x480 resolution. Programming for the TS7 resides in the System Controller and is accomplished using ELAN’s configuration software. See the ELAN configuration Reference Guide and Integration Notes for programming and setup information for your specific system components.
Volume Up Sleep Mode Press to increase the volume in the zone. Press to put the TS7 into Sleep Mode, press and hold to power the TS7 off. Volume Down When the TS7 is off, pressing will turn the panel Press to decrease the volume in the zone.
Chapter 2: System Design and Installation Planning Before installing the TS7, it is essential to have a detailed and accurate system design. Talk with the homeowner to make sure all expectations and design goals are explored. The first step to a good design is to map the system. It is advisable to mark up a copy of the house floor plan with speaker, touchpad, touchscreen, volume control, and equipment locations etc.
E L A N H O M E S Y S T E M S Installation The TS7 is designed to mount into a TS7BKT rough in bracket. The TS7BB back box can be used in conjunction with the TS7BKT in installations where a back box is desired. It can also be retrofitted into existing construction.
TS7 Touchscreens for outdoor use. Mounting Height The TS7 mounting height should be determined by the average height of the user. Typical mounting height is 56-60 inches (142-152 cm) from the floor to the bottom of the cutout. This will provide optimum viewing for the largest number of people.
TS7 to PPSP Connections TS7 connection to any of the ELAN Home Controllers (HC12, HC6, etc.) is accomplished using Ethernet connections. A single Cat5 connects the TS7 to the network. 16 AWG 2 conductor connects to the PPSP Power Precision Panel.
E L A N H O M E S Y S T E M S Chapter 4: Setup and Programming The TS7 is automatically added to the system when it is powered up and the Ethernet connection is made. It will automatically import the DEFAULT touchscreen settings from the ELAN configuration software.
Verify System Controller power and Ethernet gateway.” up or is offline. connections. TS7 has been set to a static IP Correct static IP address settings or use DHCP settings. address that is incompatible. TS7 hard buttons Trim bezel is not aligned properly.
Except as may be expressly provided and authorized in writing by ELAN, ELAN shall not be subject to any other obligations or liabilities whatsoever with respect to equipment manufactured by ELAN or services rendered by ELAN.