VIA!4.0-EM/VIA!7.0-EM/VIA!10.0-EM
Retro-Fit
VIA! Touch Panels can easily be installed directly into the wall (with no
rough-in bracket) when being utilized in a retro-fit application. Use the tem-
plate included in the box to carfeully mark the location to be cut. Be very
careful about AC lines, HVAC, communications wires, etc. when cutting into
a wall!
There are two ways to mount a VIA! Touch Panel when not using a rough-in
bracket:
1.
Use the clamping winglets on the side of the unit.
2.
Use the pre-drilled holes to attach the unit to a stud or other
secure point.
Tighten
(Clockwise)
Side View
Figure 3.12: Retro-Fit - Clamping Winglets
Page 24
Winglet
Up
© ELAN Home Systems 2007 • All rights reserved.
E L A N H O M E S Y S T E M S
Winglet
Down