Pre-Wire; Control, Status, Power; Video - Elan VIA!4.0-EM Installation Manual

VIA!4.0-EM/VIA!7.0-EM/VIA!10.0-EM

Pre-Wire

VIA! Touch Panels require power, control, status, and video connections to
function correctly.
• Control, Status, & Power:
• Video: RG-6 or RG-59 Coaxial Cable

Control, Status, Power

Run Cat-5 wire from the main equipment location (head-end) to the location
where the touch panel will be installed. Make sure that provisions have been
made for installation of a PVIA Wall Plate or Precision Panel (typically at the
head-end).

Video

VIA! Touch Panels have both a Video Input and a Video Loop Output for
composite video signals. Run RG-6 or RG-59 coaxial cable from the head-
end location (possibly a video switcher) to the location where the touch
panel will be installed. Be careful not to make sharp bends when installing
coax. F-to-RCA connectors will be necessary to adapt the RCA composite
output of the video source (or switcher) to the F-connector of the coax run
(see Figure 3.7). The VIA!s have female F-connectors for both Video Input
and Loop Output.
Note: VIA! Touch Panels display composite video signals (not RF).
Use an RCA "Y" cable to split the video signal going to a VIA!; a
coaxial splitter or splitter/combiner will not pass composite video
signals!
From
Video
Source
Figure 3.7: RG-6/RG-59 and F-to-RCA Adaptor
Page 20
F-to-RCA
Adaptor
© ELAN Home Systems 2007 • All rights reserved.
E L A N H O M E S Y S T E M S
Cat-5
RG-6/RG-59
Coax
To
VIA!
Video In