Sharp UP-3500 Instruction Manual page 337

I I I I I Drink dispenser misoperation file
The error caused by misoperation or missetting is stored in the drink dispenser misoperation file.
I I I I I Disposal of misoperation
The following two types of misoperation disposal are possible:
Type 1: Misoperation in the case when an incorrect GLU code is used. (The GLU code is out of the range
for the clerk or has already been used by another clerk.) Even when the clerk code inputted from
the drink dispenser has been defined by the POS terminal and a PLU has been assigned to the
drink dispenser by using the sort number, such data cannot be completely booked.
Such a misoperation is recorded in the drink dispenser misoperation file. At this time the following
data is updated:
• Totalizer for the associated department
• Totalizer for each PLU
• Stock counter (if controlled)
(Data of pertinent clerk)
• Order total
• Commission sales amount
• Non-commission sales amount
Type 2: Fatal error in the case when the clerk code or PLU code in the information (clerk code, sort
number) sent from the drink dispenser cannot be identified and the totalizers for clerk or PLUs
cannot be updated.
Such an error is recorded in the drink dispenser misoperation file without updating of totalizers.
These errors cannot be corrected with the correction operation and are roughly classified into the
following two groups :
• Errors which make it impossible to identify the PLU code.
• Errors which make it impossible to identify the clerk code.
The former error is printed out with correction disabled mark when reading the drink dispenser
misoperation file or reading the clerk report. If the clerk code cannot be identified, the error cannot
be outputted by drink dispenser misoperation file read operation, but read/reset operation is
possible in the X/Z mode. Also, if the clerk code not to be identified is later applied at the POS
terminal, this error cannot be corrected even when it is printed out in the drink dispenser error list,
being distinguished from the ordinary misoperation file reading.
I I I I I Misoperation file reading
Each clerk can display out only his/her data in the misoperation file in the REG or MGR mode.
➝
[DD_MOP READ]
The data of the drink dispenser misoperation file can be printed or displayed out as well in the OP X/Z and
X1/Z1 modes.
335