How To Program Alphanumeric Characters - Sharp UP-3500 Instruction Manual

How to Program Alphanumeric Characters

When you program alphanumeric characters, the character keyboard will be displayed as shown below.
[TEXTCOPY]
[PASTE]
[TEXT_START]
[TEXT_END]
[CANCEL]
[OK]
[NORMAL/DOUBLE] : Used to change the normal size or double size.
[INS]
[DELETE]
[BACK_SPACE]
[ ]
[ ]
[ ]
L
[ ]
[SHIFT]
[LIST]
[CAPS]
[ENTER]
200
: Used to copy the text data.
: Used to paste the text data.
: Used to skip to the start of a text.
: Used to skip to the end of a text.
: Used to cancel programming and to get back to the previous screen.
: Used to finalize programming.
: Used to switch the insert/over-write mode.
: Used to delete the character or figure at the cursor position.
: Backs up the cursor for deleting the character or figure at the left of the cursor.
: Used to control the cursor (left)
: Used to control the cursor (right)
: Used to control the cursor (down)
: Used to control the cursor (up)
: You can enter an upper-case letter by using this key. Touch this key just before you
enter the upper-case letter. You should touch this key each time you enter an
upper-case letter.
: Used to change the page of characters.
: Used to enter the capital-letters lock mode.
: Used to start a new line.