Reading (X) And Resetting (Z) Of Sales Totals; How To Take A Reading (X1, X2, Or Opx) Or Resetting (Z1, Z2, Or Opz) Report; Flash Report - Sharp UP-3500 Instruction Manual

9
Reading (X) and Resetting (Z)
of Sales Totals
• Use the reading function (X) when you need to take the reading of sales information entered after the last
resetting. You can take this reading any number of times. It does not affect the POS terminal's memory.
• Use the resetting function (Z) when you need to clear the POS terminal's memory. Resetting prints all
sales information and clears the entire memory except for the GT1 through GT3, reset count, and
consecutive number.
• X1 and Z1 reports show daily sales information. You can take these reports in the X1/Z1 mode.
• X2 and Z2 reports show periodic (monthly) consolidation information. You can take these reports in the
X2/Z2 mode.
• In the OPXZ mode, a clerk and/or cashier can take his or her report.
• If you want to stop the printing report, touch the [CANCEL] key. Even if the printing is stopped, the
consecutive number (and Z counter if you are printing a Z report) is increased by one.
Only when "clerk + cashier system" is applied to your machine, you can take both of Clerk and Cashier
reports.
I I I I I How to take a reading (X1, X2, or OPX) or resetting (Z1, Z2, or OPZ)
report
[To take a reading (X1, X2, or OPX) report]
1. Select "X1", "X2", or "OPX" MODE in the mode menu window to display the report list.
2. Select a report from the table shown on the next page.
3. If needed, enter corresponding values described in the "Data to be entered" column on the table
shown later.
4. Select a device ("DISPLAY" or "PRINT") to receive the output.
[To take a resetting (Z1, Z2, or OPZ) report]
1. Select "Z1", "Z2", or "OPZ" MODE in the mode menu window to display the report list.
2. Select a report from the table shown on the next page.
3. If needed, enter corresponding values described in the "Data to be entered" column on the table
shown later.
I I I I I Flash report
You can take flash reports (display only) in the X1 mode for department sales, cash in drawer (CID) and
sales total at the point you take the report.
1. Select "FLASH MODE" in the X1/Z1 mode menu window to display the items list.
2. Select "DEPT. SALES" to take a flash report of department sales, "CID" to take a flash report of cash in
drawer, or "SALES TOTAL" to take a flash report of sales total.
143