Installing In A Rack; Cautions For Installation; Required Tools - Samsung OfficeServ 7200 Installation Manual

CHAPTER 2. Installing Chassis
3

Installing in a Rack

This section describes how to install the OfficeServ 7200 Chassis inside a 19-inch rack
3.1

Cautions for Installation

Take the following cautions when installing the OfficeServ 7200 Chassis inside a rack:
The 19-inch rack should be a standard electric equipment rack.
When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to ventilate
cool air into the rack.
Take special caution with an enclosed-type rack that has vents on top of the rack
since hot air coming out of the vent may enter the intake vent of a system installed
above the rack.
When using an open rack, do not block the entrance of a port or fan of the
OfficeServ 7200 system.
3.2

Required Tools

A middle-sized cross screwdriver
A bracket and three screws for attaching
Chassis
Two brackets and six screws for
attaching rack
Two screws for fastening
Page 2-2
OfficeServ 7200 Installation guide/Ed.00
Figure 2.1 Tools Required for
Rack Installation
© SAMSUNG Electronics Co., Ltd.