CHAPTER 3. Mounting and Replacing Modules
3.1.1 WIM Module
The procedure for setting the jumpers and mounting optional Modules on the WIM
Module is as follows:
1) Set jumpers JP1 through JP4 of the WIM Module.
2) Align the connector of the WIM Module to that of the optional
Module(WIMD) and firmly press the optional Module downward.
Page 3-10
Figure 3.9 Jumper Setting of WIM Module
Figure 3.10 Mounting Optional Module on WIM Module
OfficeServ 7200 Installation guide/Ed.00
Using the Ethernet port of the
front panel, connect with the
LIM Module of slot 2.
Through back panel,
connect with the LIM
Module of slot 2.
WIMD
© SAMSUNG Electronics Co., Ltd.