Table of Contents
Advertisement
This chapter describes the installation procedure for the Harmony OpenAir Access
Point Model 7550 and includes a description of the LED indicators found on the unit.
Installation Procedure
Follow these steps to install the Harmony OpenAir Access Point Model 7550.
Note:
You must install a Harmony Access Point Controller before installing a Harmony
Access Point.
1.
If not already attached, firmly screw the antenna, included with the product, onto
the antenna connector using a clockwise motion. The antenna connector is
located on the side of the Access Point, as shown in Figure 1.
2. Installation
Figure 1
Attaching the Antenna
8
Advertisement
Table of Contents
