Message Alert Tone; Telephone Operation - AT&T TL86109 User Manual

Telephone operation

Answering system settings

Message alert tone

When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed. The default message alert setting is off.
Use the handset to set the remote access code:
1. Press the MENU softkey on the handset in idle mode to
enter the main menu.
2. Press CID or DIR to scroll to ANSWERING SYS, then
press the SELECT softkey.
1. Press CID or DIR to choose Mailbox 1 or Mailbox 2,
then press the SELECT softkey.
1. Use CID or DIR to scroll to Ans sys setup, then press
the SELECT softkey.
2. Press CID or DIR to scroll to Msg alert tone, then
press the SELECT softkey.
3. Press CID or DIR to choose between On and Off.
4. Press the SET softkey to confirm your setting. You hear a
confirmation tone.
Use the telephone base to set the remote access code:
1. Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
2. Press CID or DIR to scroll to Answering sys, then
press the SELECT softkey.
3. Press CID or DIR to choose Mailbox 1 or Mailbox 2,
then press the SELECT softkey.
4. Press CID or DIR to scroll to Ans sys setup, then
press the SELECT softkey.
5. Press CID or DIR to scroll to Msg alert tone, then
press the SELECT softkey.
6. Press CID or DIR to choose between On and Off.
7. Press the SET softkey to confirm your setting. You hear a
confirmation tone.
57
ANSWERING SYS
Mailbox 1
Mailbox 2
BACK SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
BACK SELECT
ANS SYS SETUP
# of ringers
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SET
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
SELECT
MSG ALERT TONE
On
Off
RECORD SET