Remote Access Code - AT&T TL86109 User Manual

Telephone settings
Answering system settings

Remote access code

A two-digit security code is required to access the
answering system remotely from any touch-tone telephone.
The preset code is 19. You can change the code to any
number from 00 to 99.
Use a handset to change the remote code:
1. Press the MENU softkey on the handset in idle mode to
enter the main menu.
2. Press CID or DIR to scroll to ANSWERING SYS, then
press the SELECT softkey.
3. Press CID or DIR to scroll to Ans sys setup, then press
the SELECT softkey.
4. Press CID or DIR to scroll to Remote code, then press
the SELECT softkey.
5. Use the dialing keys (0-9) to enter a two-digit number
from 00-99, then press the SET softkey to confirm.
• Press
OFF
• Press CID
the right.
Use the telephone base to change the remote code:
1. Press the MENU softkey on the handset in idle mode to
enter the main menu.
2. Press CID or DIR to scroll to Answering sys, then
press the SELECT softkey.
3. Use CID or DIR to scroll to Ans sys setup, then press
/SELECT.
MENU
4. Press CID or DIR to scroll to Remote code, then
press the SELECT softkey.
5. Use the dialing keys (0-9) to enter a two-digit number
from 00-99, then press the SET softkey to confirm.
• Press CANCEL to erase a digit.
• Press CID
the right.
/CLEAR to erase a digit.
to move the cursor to the left or DIR to
to move the cursor to the left or DIR to
56
ANSWERING SYS
Mailbox 1
Mailbox 2
BACK SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
BACK SELECT
ANS SYS SETUP
Remote code
Msg alert tone
Recording time
BACK SELECT
REMOTE CODE
19
BACK SET
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
SELECT
ANS SYS SETUP
Remote code
Msg alert tone
Recording time
REC SELECT
REMOTE CODE
On
19
RECORD SET