Effect, Intensity - ETC ColorSource 20 User Manual

Aspect- Shape effects may be squashed on one of their axes. This can used to fit a shape effect to
a stage area or scenic element. Positive Aspect progressively squashes the tilt axis while negative
Aspect progressively squashes the pan axis.
Running Effect Control
When effects run an icon is displayed in the vertical area to the right of the
ted at any time to manipulate the effects.
Effects may be edited, removed, or reduced via the wheel control when they are playing back from
backs or cues.

Effect, Intensity

Applies intensity effects to chosen channels.
Note:
control channel.
How to Apply an Intensity Effect
1. Select some channels.
2. Go to Controls>Effects.
3. Press
4. Choose the intensity tab from the tab area.
5. Select a pattern.
6. Adjust the effect settings for the desired result.
Effect Settings
Depth- The amount that the effect deviates from the static intensity set on the light. When set to full
the light follows the effect entirely, and will range from zero to full. When set to 50% the resulting
effect will be half way between the light's static rest-state intensity (the brightness it was before the
effect was chosen), and so on.
Speed- The speed or rate that the effect runs at.
Fan- The amount the effect is spread-out over the selected lights. With no fan all the lights change
together at the same time. With increasing values of fan the lights respond to different parts of the
effect, offset from each other.
46
Intensity effects may only be applied to devices that produce light and have an intensity
Add Effect.
Note:
For the intensity to vary fully between zero and full you should set the rest-state
value to 50%, then the effect can both raise and lower the intensity by the full amount pos-
sible.
Note:
The order in which the lights are selected will affect how they are spread-out by
the fan setting.
stage map. This may be selec-
play-
Using Effects