Toyota PRIUS Owner's Manual page 630

630
7-2. Steps to take in an emergency
Attach the air release cap to the
17
end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
Temporarily store the bottle in the luggage compartment while it is
18
connected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
19
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving, stop your vehicle
20
in a safe place on a hard, flat
surface
repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
Turn the compressor switch on and wait for several seconds, then
21
turn it off. Check the tire inflation pressure.
If the tire inflation pressure is
1
under 130 kPa (1.3 kgf/cm
or bar, 19 psi): The puncture
cannot be repaired. Contact
any authorized Toyota dealer
or repairer, or another duly
qualified and equipped pro-
fessional.
If the tire inflation pressure is 130 kPa (1.3 kgf/cm
2
or higher, but less than the specified air pressure: Proceed to
step
If the tire inflation pressure is the specified air pressure (→P. 667):
3
Proceed to step
PRIUS_OM_OM47A31E_(EE)
and reconnect
.
22
.
23
the
2
2
or bar, 19 psi)