Toyota PRIUS Owner's Manual page 441

Multi-information display messages
When the Simple Intelligent Parking Assist System cannot be oper-
ated, or when operation is stopped, canceled, etc., the one of the fol-
lowing message is displayed on the multi-information display. Take
appropriate action according to the display.
When it is not possible to operate
■
Message
PRIUS_OM_OM47A31E_(EE)
4-5. Using the driving support systems
Situation•Handling method
The system may be malfunctioning.
→ Turn the power switch off and then to ON
mode.
Have the vehicle inspected by any authorized
Toyota dealer or repairer, or another duly
qualified and equipped professional if the
message is displayed again.
There may be a system failure.
Power steering equipment is temporarily overheat-
ing.
→ Turn the power switch off, wait for a little
while, and then turn the power switch back to
ON mode.
The power switch is not in ON mode.
→ Turn the power switch to ON mode.
Ice, snow, dirt, etc., has adhered to the sensor.
→ Remove any ice, snow, dirt, etc.
The sensor is frozen.
→ Once the sensor thaws, the system will return
to normal.
The battery has been removed and reinstalled.
→ Drive the vehicle straight ahead for 5 seconds
or more at a speed of approximately 35 km/h
(22 mph) or higher.
The S-IPA switch is operated when the vehicle
speed exceeds 30 km/h (16mph).
→ Operate the switch when the vehicle speed is
approximately 30 km/h (16mph) or less.
441
4