Toyota PRIUS Owner's Manual page 629

Inflate the tire until the specified air pressure is reached.
14
The sealant will be injected
1
and the pressure will spike to
between 300 kPa (3.0 kgf/cm
or bar, 44 psi) and 400 kPa
(4.0 kgf/cm
then gradually decrease.
The air pressure gauge will
2
display the actual tire infla-
tion pressure about 1 to 5
minutes after the switch is
turned on.
• Turn the compressor switch
off and then check the tire
inflation
careful not to over inflate,
check and repeat the inflation
procedure until the specified
tire
reached.
• The tire can be inflated for about 5 to 20 minutes (depending on
the outside temperature). If the tire inflation pressure is still lower
than the specified point after inflation for 25 minutes, the tire is
too damaged to be repaired. Turn the compressor switch off and
contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
• If the tire inflation pressure exceeds the specified air pressure, let
out some air to adjust the tire inflation pressure. (→P. 632, 667)
With the compressor switch off, disconnect the hose from the valve
15
on the tire and then pull out the power plug from the power outlet
socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
16
PRIUS_OM_OM47A31E_(EE)
2
or bar, 58 psi),
pressure. Being
inflation pressure
7-2. Steps to take in an emergency
2
is
629
7