ABB Navigator 600 Silica User Manual page 74

Navigator 600 Silica
Single-stream
Icon
Out of Cleaning Solution
The cleaning solution bottle is empty.
1. Replace the cleaning solution.
2. At the 'Calibration & Maintenance' level, select 'Solution
Replacement' and at the 'Replace Cleaning Solution'
parameter, press the
been replaced.
Out of Secondary Calibration Solution
The secondary calibration solution bottle is empty.
1. Replace the secondary calibration solution.
2. At the 'Calibration & Maintenance' level, select 'Solution
Replacement' and at the 'Replace Sec. Calibration Solution'
parameter, press the
been replaced.
* Limits can be set – see Section 5.4.3, page 33
Table B.1 Diagnostic Information, Relay Operations and Inhibits (Sheet 7 of 7)
72
Diagnostic message
key to confirm that solution has
key to confirm that solution has
Appendix B – Diagnostics and Alarms
Out-of- Cal. in
Hold
Service Progress
Relay
Relay Relay
Cal.
Failed Inhibits
Relay
Scheduled
cleans
Scheduled
secondary
calibration
IM/NAV6S/SS–EN Rev. E