Mounting The Analyzer; Mounting The Reagent Shelf (Optional) - ABB Navigator 600 Silica User Manual

Navigator 600 Silica
Single-stream

4.5.2 Mounting the Analyzer

Dimensions in mm (in.)
525
(20.7)
Fig. 4.6 Mounting the Analyzer
Note. Clearance – the enclosure doors can open 180°. If
mounting in a confined area, allow sufficient clearance for
cables on the door hinge side (min. 270 mm, 10.6 in.) and
100 mm (3.93 in.) on door opening side.
Referring to Fig. 4.6:
1. Mark the wall using the dimensions shown or, with the
analyzer supported carefully against the wall, mark
through the mounting holes.
A
2. Drill and plug 3 holes
fixings.
3. Screw in top fixing
(0.78 in.) between the fixing head and the wall.
4. Hang the analyzer onto fixing
retained firmly against the wall.
Note. It is not possible to adjust fixing
analyzer is placed over it. If necessary, remove the
analyzer and adjust the fixing.
5. Secure the analyzer to the wall using 2 fixings
IM/NAV6S/SS–EN Rev. E
200
(7.8)
B
and , suitable for M6 or
A
, leaving a gap of 20 mm
A
, ensuring the analyzer is
A
once the
B
.

4.5.3 Mounting the Reagent Shelf (Optional)

All Dimensions in mm (in.)
165
(6.59)
82
(3.23)
81
(3.18)
Fig. 4.7 Reagent Mounting Shelf (option)
If used, mount the reagent shelve(s) no more than 1 m (3.3 ft.)
from the analyzer's bottom plate – see Fig. 4.5, page 16. Each
shelf can be attached through the back plate or either of the
side plates. If two shelves are attached through their side plates,
ensure they are arranged with the back plates facing each other.
Referring to Fig. 4.7:
1. Mark the wall using the dimensions shown or, with the
shelf supported carefully against the wall, mark through
the mounting holes.
2. For each shelf, drill and plug holes suitable for M8 or
5 / in. fixings.
16
3. Hang the shelf onto the screws and tighten the fixings to
secure the shelf firmly against the wall.
1
/ in.
4
114 165
(4.48) (6.59)
75 76
75
(2.95) (3.00)
(2.95)
4 Installation
17