Security - ABB Navigator 600 Silica User Manual

Navigator 600 Silica
Single-stream

5.3.4 Security

'User 1' is the System Administrator and is the only user that has access to the 'Security type' parameter. User 1 details cannot be
changed by any other user.
There are two types of security:

Basic
Enables up to four users to have access to the 'Configuration' menu. Each user has a password that can have up to four digits.
A separate password can be set to gain access to the 'Calibration & Maintenance' and 'Logging' menus. All four users use this
password.

Advanced
Enables up to twelve users to have password-protected access to any of the 'Configuration', 'Calibration & Maintenance' or
'Logging' menus. Each user can be assigned a unique 20-digit (alphanumeric) case-sensitive password. A minimum password
length can be set.
Note. A separate password for access to the 'Calibration & Maintenance' and 'Logging' menus is not required.
User 1 can set permissions for each user to access the 'Calibration & Maintenance' and / or 'Logging' menus. Access to the
'Configuration' menu can also be set – see Section 5.3.5, page 30.
– Passwords are set by User 1. If permissions are set, users can subsequently change their own passwords.
– Password expiry dates can be set.
– Inactive user accounts can be disabled after a set time.
– Password failure limits can be set.
– A minimum password length can be set.
28
5 Configuration
IM/NAV6S/SS–EN Rev. E