DFI RM641-HD User Manual page 14

4. Unlock the socket by pushing the load lever down, moving it sideways until it is released
from the retention tab; then lift the load lever up.
5. Lift the load lever to lift the load plate. Lift the load lever up to the angle shown on the
photo.
Chapter 3 Installing the Device
Load lever
Retention tab
Chapter 3
The CPU's notch will at the same time fit
into the socket's alignment key.
Alignment key
7. Insert the CPU into the socket. The gold triangular mark on the CPU must align with the
corner of the CPU socket shown on the photo.
8. Close the load plate then push the load lever down. While closing the load plate, make
sure the front edge of the load plate slides under the retention knob.
9. Hook the load lever under the retention tab.
Important:
The CPU will fit in only one orientation and can easily be inserted without exerting
any force.
14
Alignment key
www.dfi.com