Table of Contents
Advertisement
6.14.2.2 Log Settings
The IPsec Log can be used to identify and analyze the history of the IPsec pack-
age commands, attempts to create connections, etc. IPsec activity, as well as
that of other GlobeSurfer 3G modules, is displayed together in this view.
1. Click the IPsec icon from the Advanced screen.
2. Click Log settings. The IPsec log settings screen will appear.
3. Select the check-boxes relevant to the information you would like the
IPsec log to record.
6.14.3 Advanced IPsec Connection Settings
The IPsec connections are displayed in the Connections section of the IPsec set-
tings screen (see figure 6.43). To configure advanced IPsec settings perform the
following steps:
1. Click the connection's Edit icon in the Action column. The Connection
properties screen will appear (see figure 6.45)
Figure 6.45: IPsec Connection Properties
2. Click the Settings button. The Configure IPsec connection screen will ap-
pear, enabling you to configure the following advanced IPsec settings:
Remote tunnel endpoint address The IP address of your IPsec peer.
Security Association Mode Mode can be Tunneling or Transport. Trans-
port mode needs no explicit configuration. Tunneling mode requires
that you configure the following parameters:
• Local subnet
• Local subnet mask
• Remote subnet
• Remote subnet mask
• Compress (Support IPCOMP protocol): Select this check-box to
use the IPComp protocol.
174
Advertisement
Table of Contents
