Settings - Siemens siprotec 7SD610 User Manual

to Enabl. w. comp. (available with compounding). Do not use compounding in lines
with series capacitors!
For the trip circuit supervision set at address 140 Trip Cir. Sup. the number of
trip circuits to be monitored: 1 trip circuit, 2 trip circuits or 3 trip
circuits, unless you omit it (Disabled).
If the device is connected to voltage transformers, set this condition in address 144V-
TRANSFORMER. The voltage dependent functions, such as the directional time over-
current stages or the determination of voltage related measuring values can only be
activated by the device if voltage transformers are connected.
If a power transformer is located within the protected zone, set this condition in
address 143 TRANSFORMER order option). The transformer data themselves are then
polled when parameterizing the general porotection data (see 2.1.4.1).
2.1.1.3

Settings

Addr. Parameter
103 Grp Chge OPTION
110 Trip mode
112 DIFF.PROTECTION
122 DTT Direct Trip
124 HS/SOTF-O/C
126 Back-Up O/C
133 Auto Reclose
134 AR control mode
136 FREQUENCY Prot.
137 U/O VOLTAGE
139 BREAKER FAILURE
7SD610 Manual
C53000-G1176-C145-4
Setting Options
Disabled
Enabled
3pole only
1-/3pole
Enabled
Disabled
Disabled
Enabled
Disabled
Enabled
Disabled
TOC IEC
TOC ANSI
1 AR-cycle
2 AR-cycles
3 AR-cycles
4 AR-cycles
5 AR-cycles
6 AR-cycles
7 AR-cycles
8 AR-cycles
ADT
Disabled
Pickup w/ Tact
Pickup w/o Tact
Trip w/ Tact
Trip w/o Tact
Disabled
Enabled
Disabled
Enabled
Enabl. w. comp.
Disabled
Enabled
enabled w/ 3I0>
Default Setting
Disabled Setting Group Change Option
3pole only Trip mode
Enabled Differential protection
Disabled DTT Direct Transfer Trip
Disabled Instantaneous HighSpeed/SOTF
Overcurrent
TOC IEC Backup overcurrent
Disabled Auto-Reclose Function
Trip w/o Tact Auto-Reclose control mode
Disabled Over / Underfrequency Protection
Disabled Under / Overvoltage Protection
Disabled Breaker Failure Protection
2.1 General
Comments
31