Neopost IJ 70 User Manual page 63

Remove the label, pull media, close the cover, and cut excess of
paper.
- Switch off the RTD.
- Disconnect the RTD from the base or switch the base off.
- Switch on the RTD.
- Wait 10 seconds.
- Press and hold the feed button
- Cut the test label.
- To reconnect to the base:
In case of paper type change ONLY, it is possible to adjust the
print density:
- Select the SUPERV. SETUP menu, the following menu is
4127389N/C
02/28/2007
Jam clearing
Stand alone test
- Switch off the RTD;
- Connect the cable to the base;
- Switch on the RTD.
Supervisor mode
displayed:
SUPERV SETUP
SUP
HOME SETUP
Operation with a roll tape dispenser (RTD)
until the test label output.
1 SECURITY 1 SECURITY
2 TIME
3 TIMEOUT
5 LOAD RATE
6 DYNAMIC SCALE TESTS
7 SERIAL PORT SETUP
ORIG0002-63/A
OK
63