Managing Drive Scsi Cables - HP StorageWorks ESL E-Series Installation Manual

a. Gently tighten the screws to secure the cable to the drive port using a slotted screwdriver.
CAUTION: Do not overtighten the screws that secure the cable to the drive port.
b. Route it through the cable access holes in the sheet metal on the right of the library cabinet.
For drive clusters 0 through 2, dip the excess cable length down into the upper cable access
hole. For drive clusters 3 through 5, route the cables up through the lower and upper access
holes. Push the first set of cables to the back of the library to create space for additional
cables. This will help prevent the cables from becoming tangled. See
Figure 33

Managing drive SCSI cables

CAUTION: When routing cables through the cable access holes, be careful not to dislodge or
2
damage the I C cable attached to the cluster controller card.
c. Continue routing the cable up through the cable restraint bracket located to the right of the
card cage and attach the cable to the corresponding SCSI port on the e2400-160 interface
controller.
ESL E-Series Tape Library unpacking and installation guide
Figure 33.
45