Connecting The Cabinet Controller Scsi Cable - HP StorageWorks ESL E-Series Installation Manual

Connecting the cabinet controller SCSI cable

1. Locate the SCSI cable attached to the cabinet controller. If not already attached, attach it now
(see Figure
Figure 29 Connecting the robotics controller card (e1200-160)
2. Route the SCSI cable from the cabinet controller up through the cable access holes to the right of
the drive clusters.
3. Continue routing through the cluster cable clamp at the top right of the uppermost drive cluster.
4. Connect the other end to Port 0 of the robotics controller card (e1200-160), located in the card
cage at the top of the library (see
42 Installing the library
29).
Figure 29).