Storing The Panel Shipping Restraints - HP StorageWorks ESL E-Series Installation Manual

16.Store the panel shipping restraint hardware (three sets on each side) on the lower cabinet frame
(see Figure 23).
1
1 Panel restraint storage location (left side shown)
Figure 23

Storing the panel shipping restraints

17. Using the power cables from the accessory kit, connect the library to a grounded power source,
using the following procedure.
a. Connect the cables to the library's main power source.
b. Route the cables through the cable access hole at the bottom of the cabinet.
c. Connect the cables to a grounded power source.
NOTE: Do not power on the library. The two breaker switches on the power distribution unit should
remain in the off position (to the left) until the library is fully installed.
WARNING! This product can only be used with an HP approved power cord for your specific
geographic region. Use of a non-HP approved power cord may result in: 1) not meeting individual
country specific safety requirements; 2) insufficient conductor ampacity that could result in
overheating with potential personal injury and/or property damage; and 3) an unapproved power
cord could fracture resulting in the internal contacts being exposed, which potentially could subject
the user to a shock hazard. HP disclaims all liability in the event a non-HP approved power cord is
used.
ESL E-Series Tape Library unpacking and installation guide 33