Table of Contents
Advertisement
Installing and Configuring the Tape Drive for the
NonStop S-Series Server
Note. The tape drive's SCSI ID comes preconfigured to SCSI ID 5. If you need to change
the SCSI ID, use a screwdriver. Do not use a lead pencil.
4. Connect one end of the SCSI cable to the top SCSI port at the rear of the tape
drive. See
Figure 2-2. Rear View of Tape Drive
AC Power Receptacle
5. Hand tighten the screws to secure the cable to the unit.
6. Connect the opposite end of the SCSI cable to the NonStop S-series server.
The tape drive can connect to the
the NonStop S-series server.
You can use any of the SCSI cables listed in
Table 2-1. SCSI Cables
Model Number
519-003W
519-015W
519-020W
519-023W
7.
Place a terminator on the bottom SCSI port of the tape drive.
8. Check that the power button on the front of the tape drive is off.
9. Connect the power cord to the AC power receptacle on the rear of the tape drive.
Check that the power cord is fully seated.
Figure 2-2
for the location.
Fan
Description
3 meter copper SCSI cable
15 meter copper SCSI cable
20 meter copper SCSI cable
23 meter copper SCSI cable
5243 Tape Drive Installation and User's Guide —542758-003
SCSI Ports
ServerNet/DA
IOMF2 CRU, or PMF CRU
,
Table
2-1.
2 -2
Installation
SCSI ID
on
Advertisement
Table of Contents
