Connect The Td Cables To The Td Ports On The Interface Controller - HP StorageWorks ESL E-Series Installation Manual

Ensure that the bracket is positioned so that the screw holes in the bracket align with the
holes in the card cage.
c. Using one of the screws provided, secure the top hole of the bracket to the library card cage.
d. Position the cable clip so that the screw hole is aligned with the lower screw hole on the
cable bracket.
e. Using the remaining screw, secure the cable clip and the cable bracket to the library card
cage.
NOTE: FC cables are labeled near their connectors to indicate which TD port to connect to each
drive. Plan to first connect the FC cables to the interface controller, then route them through the
cabinet, and finally, connect them to the drive.
3. Connect all four TD cables to the TD ports on the interface controller (see
use the cable appropriately labeled for the port, identified as TD0, TD 1, TD2, or TD3.
1 TD ports
Figure 40

Connect the TD cables to the TD ports on the interface controller

Insert the FC cable bundle into the cable bracket to the right of the card cage.
4.
5. Route the cable through the cable access holes in the sheet metal on the right of the library
cabinet.
• For drive clusters 0 through 2, dip the excess cable length down into the upper cable access
hole.
• For drive clusters 3 through 5, route the cables up through the lower and upper access holes.
• Push the first set of cables to the back of the library to create space for additional cables.
This will help prevent the cables from becoming tangled.
6. Using a #2 Phillips screwdriver, remove the screw from the clamp located on the lower right side
of the drive cluster.
7. Route the FC cable bundle through this clamp.
8. Secure the clamp to the cluster frame by replacing the screw.
9. Remove FC port A end caps from each drive that is present.
50 Installing the library
1
Figure 40). For each,