Preparing The Cable Restraint Bracket - HP StorageWorks ESL E-Series Installation Manual

2. Remove the top screw from the cable restraint bracket and loosen the bottom one to prepare for
cable routing (see
Figure 31

Preparing the cable restraint bracket

3. Connect the SCSI cables from the drives in drive cluster 0 to the e2400-160 interface controller
in slot 0 of the card cage (see
Figure 32 Matching drives and interface controller ports
NOTE: Drive SCSI cables are labeled "A", "B", "C", and "D" on the drive end to indicate the drive
location. Drive SCSI cables are labeled "0", "1", "2", and "3" on the interface controller end to
indicate the SCSI port location. The most efficient order for making these connections is as follows:
1. Connect a SCSI cable from drive D to port 3 on the interface controller.
2. Connect a SCSI cable from drive B to port 1 on the interface controller.
3. Connect a SCSI cable from drive C to port 2 on the interface controller.
4. Connect a SCSI cable from drive A to port 0 on the interface controller.
44 Installing the library
Figure 31).
Figure 32).
0 1
B
D
2 3
A
C
10116