Connecting Fc Cable(S) To An Ultrium 460-Fc Or 960 Drive - HP StorageWorks ESL E-Series Installation Manual

6. Route the SCSI cables through the cluster cable clamp on the lower right corner of the cluster
frame (see
Figure 36 Routing through the cluster cable clamp
a. Using a #2 Phillips screwdriver, remove the screw from the clamp.
b. Route the SCSI cables through the clamp.
c. Secure the clamp to the cluster frame by replacing the screw.
7. Repeat step 2
in the library.

Connecting FC cable(s) to an Ultrium 460-FC or 960 drive

NOTE: Each e2400-FC 2GB interface controller card ships with four FC cables, one Ethernet
cable, and a cable bracket and clamp. These parts will be needed for the following procedures.
NOTE: A step stool may be needed to reach the e2400-FC 2GB interface controllers in the card
cage located at the top of the library cabinet.
48 Installing the library
Figure 36).
through step 6 for each interface controller and drive cluster combination installed