Display Screens & Diagnostic Information Access - Baldor 29M Installation And Operating Manual

Display Mode Continued
Display Screens & Diagnostic Information Access
Action
Apply Power
Press DISP key
Press DISP key
Press ENTER key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
MN1230
Description
Display mode showing motor
speed.
Scroll to diagnostic info block.
Access diagnostic information.
Display mode showing control
temperature.
Display mode showing bus
voltage.
Display mode showing %
overload current remaining.
Display mode showing opto
inputs & outputs state.
0=Open, 1=Closed.
Display mode showing actual
drive running time.
Display mode showing operating
zone, voltage and control type.
Display mode showing continuous
amps; PK amps rating; amps/volt
scale of feedback, power base ID.
Display mode showing which
Group1 or 2 expansion boards
are installed.
Display mode showing motor
shaft revolutions from the REV
home set point.
Display mode showing parameter
table selected.
Display mode showing software
version and revision installed in
the control.
Displays exit choice.
Display
Logo display for 5 seconds.
No faults present. Local keypad
mode. If in remote/serial mode,
press local for this display.
First screen in Display Mode.
Displays commanded speed,
direction of rotation, Local/
Remote.
Displays operating temperature in
degrees C.
Opto Inputs states (Left);
Opto Outputs states (Right).
HR.MIN.SEC format.
XXX-X.XX
Press ENTER to exit diagnostic
information.
Programming & Operation 4-3
Comments