Changing Parameter Values When Security Code Not Used - Baldor 29M Installation And Operating Manual

Program Mode Continued

Changing Parameter Values when Security Code Not Used

Action
Apply Power
Press PROG key
Press Y or
key
Press PROG key
Press Y key
Press ENTER or PROG
Press Y key
Press ENTER key
Press DISP key
4-6 Programming & Operation
Use the following procedure to program or change a parameter already programmed into
the control when a security code is not being used.
The example shown changes the operating mode from Keypad to Bipolar.
Description
Keypad Display shows this
opening message.
If no faults and programmed for
LOCAL operation.
Access programming mode.
Scroll to Level 1 Input Block.
Then press ENTER to access
Input Block.
Access Operating Mode.
Scroll to make your selection.
Save selection to memory.
Scroll to menu exit.
Return to Input Block.
Return to Display Mode.
Display
Logo display for 5 seconds.
Display mode. Stop LED on.
Press ENTER to access INPUT
block parameter.
Keypad mode shown is the
factory setting.
Typical selection.
Press RESET to cancel selection
without saving to memory.
Typical display mode.
Comments
MN1230