Schwinn MPower Echelon2 Service Manual page 47

System Settings Defined
Carbon Blue
This setting is used to distinguish between Carbon Blue bike with a belt and bikes with a chain. The default setting is ON.
Leave this setting set to ON for Carbon Blue models. On models with chain, set it to OFF.
Gear
This is an optional setting that enables the console to display a gear number that corresponds to the level of resistance.
When set to ON, a gear symbol and gear number will be displayed on the right side of the console next to the calories
value. This setting is set to OFF by default.
Units
The units refer to the distance. The two optional settings are miles or kilometers. The default setting is miles.
Open Ant Channel
This setting is used to turn on the channel that broadcasts data to external leaderboard systems that display console
data on a large screen. This must be set to ON in order for external systems to read data from the console. It is set to OFF
by default. Leaving this setting off when not used conserves battery life.
Backlight
This setting allows the user to set the backlight display to a number of settings. In the BACKLIGHT SETTING submenu the
backlight can be set as follows:
• Backlight displays for 10 seconds when the LIGHT button is pressed in Ride mode (this is the default setting).
• Backlight displays for 15 seconds when the LIGHT button is pressed in Ride mode.
• Backlight displays for 20 seconds when the light button is pressed in Ride mode.
• When set to ON, the backlight will always be on when the console is on.
• When set to OFF, the backlight cannot be used when the console is on.
In the BACKLIGHT HOLD submenu the backlight display can be set as follows:
• When set to ON, the rider can press and hold the LIGHT button for 5 seconds, allowing the backlight to remain
on until the rider presses the LIGHT button again to turn off the light.
• When set to OFF, the backlight hold display cannot be used.
Calories
This is an optional setting that enables the user to turn the calorie (CAL) display ON or OFF. This setting is set to ON by
default. NOTE: This optional setting is not available in firmware version V1.0. It is available only in firmware version V1.1
and later.
Batteries
The battery strength is displayed on the BATTERIES screen.
Page 47