Schwinn MPower Echelon2 Service Manual page 14

3. Tighten the screws using the 3mm hex key
4. Slide the console onto the bracket. Insert the M3 x 6mm pan
head screw and tighten with the screw driver
5. Prior to installing the upper conduit, clean head tube with
isopropyl alcohol. Allow to air dry.
6. Peel off backing adhesive and align duct part number 740-
8875-001 to forward edge and lower edge of the frame tube.
Apply normal pressure for 5 seconds
Note: It is recommended that the adhesive set for 24 hours
before use.
7. Insert the cable through the slot
Page 14