Pause Mode - Schwinn MPower Echelon2 Service Manual

If the battery level is too low to continue operation, the console display flashes the message "LO batt" and the console
goes into Sleep Mode. If this occurs during a workout, the workout stops and the console display shows the workout
results for 10 seconds. Then the "LO batt" message displays and the console goes into Sleep Mode.
Bike Sensor Data
The console receives data from the bike's sensors and uses the data to calculate workout results.
- RPM Sensor: The Schwinn® console comes with a RPM sensor for the bike. This sensor transmits data from
the flywheel to the power sensor and the console.
- Power (Watts) Sensor: The Power sensor is an optional upgrade. The power sensor calculates rider Power
(Watts) production from the brake resistance mechanism.

Pause Mode

During the ride, the console collects user data to calculate and record workout data. Proximity linking to the user's HRM
or ANT+ watch also automatically occurs after console startup..
Use the appropriate instruction for monitoring equipment.
- USB storage device --install the device in the USB port.
- ANT+ watch --link to the console. Move the watch to 2"-4" (5-10 cm) or less from the ANT+ Link Here icon on
the console and hold it there until proximity linking is complete.
- ANT+ HRM --link to the console. Lean into the console so that the HRM is 7.5"-31" (20-80 cm) from the ANT+
Link Here logo, until a value is displayed.
Note: If you have an ANT+ Sport Watch and paired ANT+ HRM, it is only necessary for the console to link
with the sport watch. However, if you have an ANT+ Sport Watch and EM 5kHz HRM, the console links to
the watch and the HRM. Visit
sole uses the ANT+ Fitness profile.
www.thisisant.com for a directory of compatible devices. The Schwinn con-
Page 11