Schwinn MPower Echelon2 Service Manual page 33

4. Plug console cable into the RJ45 connector, and the RPM cable
into the 2-pin connector on the power sensor. Slide each cable's
grommet into their respective slots in the power sensor case.
5. Attach sensor case to the resistance mechanism using the M4 x
6mm button head screws. Use blue thread lock on the screws to
ensure the sensor mounts fully.
NOTE: Be sure that sensor case sits tight against the black plate of
the resistance mechanism. All wires must be contained within the
sensor cover and not protrude from the sensor cover, which will
prevent the cover from being completely seated
6. Reinstall sweat guard.
IMPORTANT: Before using the console with the power upgrade
kit for the first time, the power sensor must be calibrated.
the next page for instructions on calibrating the power sensor.
Go to
Page 33