Ordering - GE T35 Instruction Manual

2.1 INTRODUCTION
2
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Breaker Arcing Current I
Breaker Control
Contact Inputs (up to 96)
Contact Outputs (up to 64)
Control Pushbuttons
Data Logger
Digital Counters
Direct Inputs/Outputs (32)
Disconnect Switches
DNP 3.0 or IEC 60870-5-104 Protocol
Ethernet Global Data Protocol (optional)
a) OVERVIEW
The T35 is available as a 19-inch rack horizontal mount or reduced-size (¾) vertical unit and consists of the following mod-
ules: power supply, CPU, CT/VT, digital input and output, transducer input and output, and inter-relay communications.
Each of these modules can be supplied in a number of configurations specified at the time of ordering. The information
required to completely specify the relay is provided in the following tables (see chapter 3 for full details of relay modules).
Order codes are subject to change without notice. Refer to the GE Multilin ordering page at
http://www.gedigitalenergy.com/multilin/order.htm
NOTE
2-2
51G
Restraint Amps
51P-1
Transducer Input
T35
Transformer Management Relay
Figure 2–1: SINGLE LINE DIAGRAM
FUNCTION
2
t Event Recorder
FlexElements™ (16)
FlexLogic™ Equations
IEC 61850 Communications (optional)
Metering: Current, Voltage, Power,
Modbus Communications
Modbus User Map
Non-Volatile Latches
Non-Volatile Selector Switch
Oscillography
T35 Transformer Protection System
Measure Measure
3I_0 3I_0
Calculate Calculate
Calculate
Operate Amps
2nd, 5th harmonics
50/87
87T
Metering
FlexElement
Power Factor, Frequency
for the latest details concerning T35 ordering options.
2 PRODUCT DESCRIPTION
51G
51P-2
TM
828725A3.CDR
FUNCTION
Setting Groups (6)
Time Synchronization over SNTP
Transducer Inputs/Outputs
Trip Bus
User Definable Displays
User-Programmable Fault Reports
User Programmable LEDs
User Programmable Pushbuttons
User Programmable Self-Tests
Virtual Inputs (64)
Virtual Outputs (96)

2.1.2 ORDERING

GE Multilin