Motor/Feed Test - Canon imageFORMULA DR-M160 Service Manual

CHAPTER 5 TROUBLESHOOTING
moved.
3) Panel unit
Job Select
Figure 5-228
When a button on the panel unit is
pressed, the corresponding mark lights.
5-18
Power button
Start Stop DFR
COPYRIGHT © CANON ELECTRONICS INC. 2011

3. Motor/Feed Test

This mode checks the operation of the
feed motor and main motor, and checks the
actual document feed operation.
The corresponding part of the screen
and list of items is shown below.
Figure 5-229
Message
Speed Stop/Start
X Res 100/200/300/400/600 (dpi)
Y Res 100/200/300/400/600 (dpi)
Color Gray/Color
Jpeg Normal/HighQuality
Dir Forward/Reverse
Note: Initial values are underlined. The "Dir"
for the main motor is forward rotation
only.
Table 5-203
Operation Procedure
1) After selecting the operating conditions
for the target motor, select [Start] to
rotate the motor. Select [Stop] to stop the
motor.
Note: The combination of X (horizontal) and
Y (vertical) resolution should be a
combination that actually exist in the
driver. Otherwise, it will not operate
correctly.
Options
CANON DR-M160 FIRST EDITION