Canon imageFORMULA DR-M160 Service Manual page 85

Display
Total Count
LED Count
Jam Count (P01)
Jam Count (P02)
Jam Count (P03)
Replaced Count (Unit1)
Replaced Count (Unit2)
Replaced Count (Unit3)
Replaced Count (Unit4)
Replaced Count (Unit5)
After changing the value, select the [Set]
button or [All Set] button at the right side of
each item to apply the changed value.
To close the screen, select [Close].
These values are changed when the
control PCB is replaced. After the replacing
the control PCB, the values need to be input.
If you don't know the values before
replacement, you
values.
If you replace the control PCB or change
the [Total Count], then the counter for
[Current Rollers] on the user maintenance
screen is also updated. Since the [Replace
Rollers] message may be displayed the next
time the user turns the power on or the
counter for the [Current Rollers] may take on
an invalid value, you should check the
counter for the [Current Rollers] after exiting
COPYRIGHT © CANON ELECTRONICS INC. 2011
Total number of sheets that have been fed.
Total amount of time that the LED used by the reading unit (upper
and lower) has been alight. Note that the units are in "seconds".
1000 hours = 3,600,000 seconds.
The number of paper jams in the pickup unit. Error code P001.
The number of paper jams in the registration unit. Error code
P002/006/007.
The number of paper jams in the eject unit. Error code P004.
Number of feeds when replacing the user replaceable parts (rough
guide to replacement of 200,000 sheets). This displays the total
number of sheets fed when reset in user mode.
Replaced Count (Unit2) to Replaced Count (Unit5) are used by the
service technicians to manually input the total number of sheets
fed when replacing a part to serve as a rough guide until the next
replacement. The corresponding parts can be decided within each
local region or by the service technicians as necessary.
Table 5-202
can input estimated
CANON DR-M160 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Details
service mode and reset it if it is invalid.
Note: The count for the current rollers is the
value that subtracted the total sheet
fed count at the last reset from the
current total sheet fed count.
5-15