Installing The Accessories - XYZ Printing Da Vinci Jr. 2.0 Mix User Manual

Note: Please follow these steps and ensure that the guide tube and extruder are properly
installed before starating the "LOAD FILAMENT" function. Failure to install the guide tube will
disrupt filament feed.
Install the Filament Guide Tube and Extruder
Insert the filament guide tube into the feed module tube
1
port and finish two sides installation.
Connect the filament guide tube to the extruder
3
Insert the guide tube into feed module 1 and 2.
Make sure it goes all the way down, as shown in the
the illustration.
Reminder: When installing the filament guide tubes, please attach
them in an intersecting way as shown below. Turn on the power once
the installation process is complete.

Installing the Accessories

da Vinci Jr.2.0 Mix
Take the flat cable out from the right side of the
2
printer and connect it to the extruder.
Install the extruder
4
Align the extruder with the bracket and press the
extruder to attach it to the socket.
Feed
module 1
July 2016
Feed
module 2
P 5