XYZ Printing Da Vinci Jr. 2.0 Mix User Manual page 12

CALIBRATE
Calibration is enabled for this new extruder module. Please update printer firmware via XYZware before using the
new extruder.
1. Active print bed calibration by selecting "UTILITIES">"CALIBRATE">"YES" on the screen.
2. Press the detection head on the right side of the print head according to the instruction of screen message, followed
by pressing OK.
PRESS SWITCH (A)
NEXT TO EXTRUDER
[OK] TO CONTINUE
3. Wait for detecting.
4-1A. If "CALIB COMPLETED" is shown for the
detection result, and "AUTO-LEVELING
IS DISABLED NOW" is shown on the screen, it indicates
good platform levelness. Press "OK" to exit and print.
CALIB COMPLETED
AUTO-LEVELING
IS DISABLED NOW
[OK] TO RETURN
4-2A. If the detecting result is shown as "FAIL", press
"OK" to go to next page, and press "OK" again to exit.
CALIB FAILED
AUTO-LEVELING
[OK] TO CONTINUE
Note:
1.The dirt on the detection pin and the top of Extruder module will influence detection result. Make sure that
the dirt is cleaned before calibration.
2.If the residues is on the top of the Extruder module, the detection result will be shown as follows. Clean
the dirt before recalibration.
A 0000 0000 0000
B 0000 0000 0000
C 0000 0000 0000
[OK] TO RETURN
3. The printer may enable or disable auto-level based on the result of calibration. You may switch off
the function manually under "Settings".
PLEASE CONTACT
CUSTOMER SERVICE
FOR LEVEL ISSUE
[OK] TO RETURN
CALIBRATE
4-1B. If you see "AUTO-LEVELING
IS ENABLED NOW", this indicates that the print bed is slightly
unleveled. The printer will adjust the configuration based on
the detecting result automatically while "AUTO LEVEL" is
enabled. The printing mode helps to improve printing quality
with slower printing speed. You may switch off the function
under "Settings".
CALIB COMPLETED
AUTO-LEVELING
IS ENABLED NOW
[OK] TO RETURN
4-2B. And check the detecting result by going to "INFO">
"LEVELING INFO". Contact customer service for the issue
and provide the details of leveling information.
A 0317 0320 0313
B 0318 0323 0308
C 0312 0300 0440
[OK] TO RETURN
da Vinci Jr.2.0 Mix
July 2016
P 12