Using Tone - Calrec Artemis Installation And Technical Manual

USING TONE

Use of the console's internal oscillator
helps to verify connectivity and
configuration during installation.
Tone can be selected to path inputs from
the PROCESSING panel mode.
The tone to input select button is located
on the left side of the TFT screen.
Selecting this switches tone onto the
currently assigned path's input.
Selecting the Tools>Oscillator menu on
any panel brings up oscillator controls on
the row above to allow adjustment of tone
level, frequency and idents.
The Tone Clear button in this menu will
cancel all tone to path selections across
the console.
Select the Send / Route panel mode to
route the currently assigned fader to bus
outputs from the TFT touch screen above.
Note, tone can only be selected to faders
that have a DSP path assigned (see
previous page).
88 ARTEMIS
Digital Broadcast Production Console
Select tone to currently
assigned path input
Currently assigned path
(highlighted blue)
MR MR MR MR MR
SL SL SL SL SL
MR MR MR MR MR
SL SL SL SL SL
AUTOM AUTOM AUTOM AUTOM
EXT EXT EXT EXT
CUT CUT CUT CUT
STRIP STRIP STRIP STRIP
CUT/ON CUT/ON CUT/ON CUT/ON
FDR FDR FDR FDR
**Select PROCESSING mode**
MR MR MR
SL SL SL
MR MR MR
SL SL SL
AUTOM AUTOM AUTOM AUTOM
EXT EXT EXT EXT
CUT CUT CUT CUT
STRIP STRIP STRIP STRIP
CUT/ON CUT/ON CUT/ON CUT/ON
FDR FDR FDR FDR
Fader layer select
Setup & Configuration