Table of Contents
Advertisement
Repeat to add the secondary Calrec card
as another host. Click Apply to save the
changes.
Select the Serial>Serial Port page.
Select port 1 and click Edit to view the
details for the serial port. At the top of the
page, below the port label, click Change
to select the TCP sockets profile, click
Apply and then Return to Serial 1.
Select the Hardware tab and enter serial
port settings that match that of the 3rd
party controller. Common settings are;
Serial Interface: EIA-232, Speed:
115200, Data Bits: 8, Parity: Odd,
Stop Bits: 1, Flow Control: None.
Click Apply.
If a backup controller serial connection
is being used, repeat the above for serial
port 2.
Select the General tab for serial port
1. Check Connect To, and select the
primary Calrec card from the Host drop-
down list (as was previously defined from
the Network>Advanced page). Enter a
TCP Port number to match the protocol
being setup (61000 for SW-P-08, 62000
for EMBER. The CSCP port is selectable,
as defined by Calrec StudioSetup, the
default value being 49200).
Select Initiate Connection
Automatically, and check Send Name
On Connect.
If Ethernet cable and port redundancy
is required from a single serial port
controller, check Connect To Multiple
Hosts, then click Define Additional
Hosts. Click Add and select the Calrec
secondary card from the Host list, and
enter the TCP port number required
for the protocol being used. Click OK.
Ensure that Define primary and backup
78 ARTEMIS
Digital Broadcast Production Console
PERLE WEB MANAGER - NETWORK>IP ADDRESS PAGE
PERLE WEB MANAGER - NETWORK>ADVANCED PAGE
hosts to connect to is NOT selected,
and then Apply.
If there is a backup 3rd party controller
serial connection, do not select serial port
1 to connect to multiple hosts. Instead,
Configure serial port 2 to connect to the
Calrec secondary card.
192.168.1.10
192.168.2.10
255.255.0.0
255.255.0.0
192.168.1.0
192.168.2.0
Once completed, click Reboot IOLAN
or cycle the power to the unit for the
configuration changes to take.
192.168.1.10
192.168.1.10
External Control
Advertisement
Table of Contents
