Table of Contents
Advertisement
WIRELESS ROUTER CONFIGURATION – ASSIST
Calrec's Assist apps are connected
to the console via a wireless router.
The setup options provided by
different router manufacturers can
differ substantially so this setup
guide should be used along with
the manufacturer's instructions for
your particular router configuration
application. Also, some basic
networking knowledge is assumed.
Calrec serial control protocol (CSCP)
allows communication with Calrec
consoles using the TCP/IP protocol at a
pre-determined TCP port number.
Assist apps run on iPad devices which
connect to the Calrec system through a
wireless router, through which console
functions can be controlled using CSCP.
ConsoleConfiguration
From software version 1. 1 4.7 onwards,
Calrec consoles are pre-configured with a
basic 'Assist' CSCP configuration which is
disabled by default.
This basic configuration assumes a
simple, point to point connection with
a wireless router on a 192. 1 68. 1 /24
subnet. This basic setup is unlikely to be
suitable for connection to a more complex
corporate network.
To enable the basic Assist connection,
select SystemSettings from the menu
along the bottom of the main application,
then select ExtControl from the
left hand menu and click to ENABLE
'assist(CSCPv21)'.
The console will now be providing the
CSCP connections shown in this table.
CALREC
Putting Sound in the Picture
ASSIST CSCP ENABLE
IP Address
Primary Control
192. 1 68. 1 . 1
Processor
Secondary Control
192. 1 68. 1 .2
Processor
Subnet Mask
Port Number
255.255.255.0
49300
255.255.255.0
49300
73
Advertisement
Table of Contents
