Assigning Paths To Faders; Assignable Faders; Assigning Paths - Calrec Artemis Installation And Technical Manual

ASSIGNING PATHS TO FADERS

Assignablefaders
Each fader has an A and B sub-layer,
which can be switched between by
pressing the assign buttons above and
below the fader's label display. The
two sub-layers, A & B are not related
by default and can control two distinct,
unrelated audio paths. The upper half of
the fader label display is green and refers
to the A layer, the lower half is yellow and
refers to the B layer. An open fader will
remain open and passing audio after the
layer is changed.
Pressing the assign button above (A
layer) or below (B layer) the label display
makes it the currently assigned path
and highlights it blue. Only one path
(unless user splits are in place) can be
the currently assigned path at any given
time. Path specific changes are applied to
the currently assigned path. For example,
adjusting settings on an assignable panel
in PROCESSING or SEND-ROUTE
mode will affect the currently assigned
(highlighted blue) path.
In addition to A & B sub-layers, there are
in fact a total of 12 fader layers, each with
an A & B sub-layer. All layers and A/B
sub-layers are active irrespective of which
is currently visible. Fader layer is selected
from the assign row (control cell row
above the fader label row) of any panel.
Assigningpaths
A or B layer faders with a blank label
field have no DSP path assigned.
Path assignment is achieved from the
Tools>Fader Assignment menu (see
the highlighted drawing to the right).
Select New Channels to assign input
channels. Three channel widths are
currently supported - Mono, Stereo and
5. 1 . Pressing one of these buttons will
assign that channel type to the currently
assigned fader (as long as no path is
already assigned on that fader).
CALREC
Putting Sound in the Picture
MR MR MR
SL SL SL
MR MR MR
SL SL SL
AUTOM AUTOM
EXT EXT
CUT CUT CUT
STRIP STRIP
CUT/ON CUT/ON
FDR FDR
PEAK PEAK PEAK
Currently assigned path
(highlighted blue)
To assign the same channel type to
multiple faders, press and hold the
channel type button whilst selecting the
faders you wish to be assigned.
To clear a path from a fader, select the
Layer Tools menu (Button above Tools).
Press Clear Path from the row above
then Exec to clear the currently assigned
path. To clear multiple paths, press and
hold Clear Path whilst selecting the faders
to clear before confirming by pressing
Exec.
3. New channels
menu
MR MR MR
SL SL SL
MR MR MR
SL SL SL
AUTOM AUTOM AUTOM
EXT EXT EXT
CUT CUT CUT
STRIP STRIP STRIP
CUT/ON CUT/ON CUT/ON
FDR FDR FDR
PEAK PEAK PEAK
2. Fader
Assignment
MR MR
SL SL
MR MR
SL SL
AUTOM AUTOM AUTOM
EXT EXT EXT
CUT CUT
STRIP STRIP STRIP
CUT/ON CUT/ON CUT/ON
FDR FDR FDR
PEAK PEAK
1. Tools menu
87