Surface Power - Ac - Calrec Artemis Installation And Technical Manual

SURFACE POWER - AC

Artemis control surfaces have 3 x IEC
AC mains inputs requiring 100–240V
AC.
The AC power inlets are wired internally to
three distribution blocks mounted to the
base of the inside of the control surface.
The POE switches have dual power
supplies for redundancy and take two
AC inputs, one from each of the first
two mains sources. The majority of the
remaining hardware in the control surface,
SURFACE AC POWER CONNECTIONS
POE
YZ5706 - POE SWITCH
A B
USB POWER P5 P1 SPR1 AP1
GOOD
P5 P1 1 2 P - Panel
P6 P2 SPR2 AP2 S - Surface switch
AP - Ancillary Power
P6 P2 SPR - Surface switch
Power & Reset
S1 P3 RST AP3
S1 P3 RST - Reset
S2 P4 S2 P4 RST AP4
A B
Serial number
AC IN 1 AC IN 2
MU5734
1 md
04/03/08
Approved
Alpha Calrec
RTW meter 10600
Meter Module
..
..
Meter
20 ARTEMIS
Digital Broadcast Production Console
including the PC is DC powered via POE
connections.
The third IEC input and distribution block
is used to power ancillary or third party
items with a single mains input, such as
DK/RTW meters and PC monitors.
To ensure all equipment is powered and
redundancy is applied where available,
all three IEC inputs to the control surface
need to be fed with 100–240V AC. If only
one of the first two inputs is fed, System
Status error messages will be generated
POE
YZ5706 - POE SWITCH
A B
USB POWER P5 P1 SPR1 AP1
GOOD
P5 P1 1 2 P - Panel
P6 P2 SPR2 AP2 S - Surface switch
AP - Ancillary Power
P6 P2 SPR - Surface switch
Power & Reset
S1 P3 RST AP3
S1 P3 RST - Reset
S2 P4 S2 P4 RST AP4
A B
Serial number
AC IN 1 AC IN 2
PSU
Surface AC inputs
1 2 Anc
POE
USB POWER P5
GOOD
P5 P1 1 2
P6
P6 P2
S1
S1 P3
S2
S2 P4
A B
by each POE indicating they are not
receiving power on both inputs.
It is recommended that these two mains
inputs are fed from two separate AC
supplies where possible to provide
redundancy against external power failure.
YZ5706 - POE SWITCH
A B
P1 SPR1 AP1 PC MONITOR
P - Panel
P2 SPR2 AP2
S - Surface switch
AP - Ancillary Power
SPR - Surface switch
P3 RST AP3 Power & Reset
RST - Reset
P4 RST AP4
Serial number
AC IN 1 AC IN 2
Control Surface